Center Brake Pipe

Install the pipe assembly center.
1. Install the pipe assembly center.
  - Except for hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION .
  - Hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION .
2. Install each brake pipe using a flare nut wrench.
  Tightening torque:
  
  Refer to BRAKE>GENERAL DESCRIPTION>COMPONENT>CENTER BRAKE PIPES AND HOSES .
Install the support - sub frame.
Tightening torque:

Refer to REAR SUSPENSION>GENERAL DESCRIPTION>COMPONENT>REAR SUSPENSION .
Install the fuel tank.
- Except for hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL TANK>INSTALLATION .
- Hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>FUEL TANK>INSTALLATION .
Install the rear differential.
- VA-type: Refer to DIFFERENTIALS>REAR DIFFERENTIAL (VA-TYPE)>INSTALLATION .
- VB-type: Refer to DIFFERENTIALS>REAR DIFFERENTIAL (VB-TYPE)>INSTALLATION .
Install the propeller shaft assembly. Refer to DRIVE SHAFT SYSTEM>PROPELLER SHAFT>INSTALLATION .
Install the rear exhaust pipe. Refer to EXHAUST (H4DO (EXCEPT FOR HEV))>REAR EXHAUST PIPE>INSTALLATION .
Install the floor under protector RH. Refer to EXTERIOR/INTERIOR TRIM>FLOOR UNDER PROTECTOR>INSTALLATION .
Install the fuel tank protector.
- Except for hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL TANK PROTECTOR>INSTALLATION .
- Hybrid model: Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>FUEL TANK PROTECTOR>INSTALLATION .
Install the crossmember support - rear RH. Refer to FRONT SUSPENSION>CROSSMEMBER SUPPORT>INSTALLATION .
Connect the ground terminal to 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
NOTE: For the hybrid model, connect the battery negative terminal.
Bleed air from the brake line.
- Except for hybrid model: Refer to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (EXCEPT FOR HYBRID MODEL) .
- Hybrid model: Refer to BRAKE>AIR BLEEDING>PROCEDURE>BRAKE LINE (HYBRID MODEL) .
Install the rear wheels.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)