LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Entertainment System >> Audio >> Removal

Entertainment System: Audio: Removal

  1. Disconnect the ground terminal from 12V engine restart battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, disconnect the battery negative terminal.
  2. Remove the grille assembly - CTR ventilation. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>AIR VENT GRILLE>REMOVAL>CENTER GRILLE ASSEMBLY .
  3. Remove the panel - center UPR.
    1. Release the clips and claws, then detach the panel - center UPR.
      G11246744Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the audio assembly.
    1. Remove the screws.
    2. Release the clips and disconnect the connector, and then remove the audio assembly.
      G11246745Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the backup unit. Ref. to SECURITY AND LOCKS>BACKUP UNIT>REMOVAL .
  6. Remove the data communication module. (Model with telematics) Ref. to ENTERTAINMENT & MONITORING>DATA COMMUNICATION MODULE>REMOVAL>DATA COMMUNICATION MODULE .
  7. Remove the audio bracket.
    1. Remove the screws, and then remove the audio bracket.
      G13606386Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Remove the screws on LH side in the same procedure as on the RH side.
scientia non olet · About LEMON Manuals