LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> BRZ tS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service Information)) >> Transmission Valve Body ASSY >> Removal

Transmission Valve Body ASSY: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnection of the battery ground terminal (Refer to REMOVAL )
  2. Removal of exhaust pipe SUB-ASSY FR

    (Refer to REMOVAL )

  3. Draining of automatic transmission fluid
    1. Remove the drain plug and gasket to drain automatic transmission fluid.
    2. Install the drain plug via a new gasket.

      Standard value: T=20N.m {204kgf.cm} {14.8ft.lbf} 

  4. Transmission oil pan SUB-ASSY (ATM) removal (refer to REMOVAL )
  5. Removal of valve body oil strainer ASSY (refer to REMOVAL )
  6. Disconnection of transmission wire (refer to REMOVAL )
  7. Removal of transmission valve body ASSY
    1. Remove the bolt and then remove the detent spring cover and detent spring.
      G12587453Courtesy of SUBARU OF AMERICA, INC.
    2. Remove 19 bolts to remove the transmission valve body ASSY from the automatic transmission case SUB-ASSY.
      G12587454Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the lever pin from the manual valve to remove the transmission valve body ASSY.
      G12587455Courtesy of SUBARU OF AMERICA, INC.
    4. Remove the check ball body and spring.
      G12587456Courtesy of SUBARU OF AMERICA, INC.
      CAUTION: Be careful not to drop and lose the check ball body.
scientia non olet · About LEMON Manuals