Transmission Wire: Removal

(Refer to REMOVAL )

1. Remove 20 bolts to remove the transmission oil pan SUB-ASSY (ATM).
2. Remove the gasket.

   Courtesy of SUBARU OF AMERICA, INC.

3. Remove 3 magnets from the transmission oil pan SUB-ASSY (ATM).

Courtesy of SUBARU OF AMERICA, INC.

1. Remove 4 bolts to remove the valve body oil strainer ASSY.
   CAUTION: Set a tray under it to receive discharged transmission fluid.

   Courtesy of SUBARU OF AMERICA, INC.

2. Remove the O-ring from the valve body oil strainer ASSY.

Courtesy of SUBARU OF AMERICA, INC.

1. Remove the bolt and lock plate, and then disconnect the oil temperature sensor from the transmission valve body ASSY.

   Courtesy of SUBARU OF AMERICA, INC.

2. Remove the bolt to remove the clamp from the valve body ASSY.
3. Disconnect the wiring harness from the clamp.

   Courtesy of SUBARU OF AMERICA, INC.

4. Disconnect 9 connectors from each solenoid valve and disconnect the transmission wire from the transmission valve body ASSY.
   NOTE: Use a thin-tipped flat tip screwdriver for the connector indicated by the white arrow to disconnect the control solenoid connector.

   Courtesy of SUBARU OF AMERICA, INC.

1. Disconnect the transmission wire connector.
   NOTE: Release the claw and tilt the lever downward to disconnect the connector of the transmission wire.

   Courtesy of SUBARU OF AMERICA, INC.

2. Remove the bolt and pull out the transmission wire from the transmission valve body ASSY.

   Courtesy of SUBARU OF AMERICA, INC.

3. Remove the O-ring from the transmission wire connector.

   Courtesy of SUBARU OF AMERICA, INC.