LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Emission Control Systems (Aux. Emission Control Devices) (Except For STI)) >> PCV Pipe >> Installation

PCV Pipe: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Connect the quick connector of the PCV pipe assembly to the PCV connector.
    CAUTION:
    • Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
    • Make sure that the quick connector is securely connected.
    G13258762Courtesy of SUBARU OF AMERICA, INC.
  2. Install the A/C compressor. Refer to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>COMPRESSOR>INSTALLATION .
  3. Attach the clips which secure the PCV pipe assembly to the intake manifold.
    G13258763Courtesy of SUBARU OF AMERICA, INC.
  4. Install the PCV pipe assembly to the clip.
    G13258764Courtesy of SUBARU OF AMERICA, INC.
  5. Install the intake duct No. 2. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>INTAKE DUCT>INSTALLATION>INTAKE DUCT NO. 2 .
  6. Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .
  7. Charge the A/C system with refrigerant. Refer to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .
  8. Install the collector cover. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>COLLECTOR COVER>INSTALLATION .
scientia non olet · About LEMON Manuals