Transfer Drive Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the needle bearing and snap ring to the transfer drive gear.
Set the ST to the ball bearing inner race, then install the transfer drive gear.
CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).

NOTE: Use a new ball bearing.

ST 398177700 INSTALLER

Courtesy of SUBARU OF AMERICA, INC.
Install the snap ring.

Courtesy of SUBARU OF AMERICA, INC.
Inspect the clearance between the snap ring and the ball bearing. Refer to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT) (TY75)>TRANSFER DRIVE GEAR>INSPECTION .