Transfer Drive Gear: Inspection
WARNING: This page is about a different variant/trim than selected.
- Ball bearing
Replace the ball bearing in following cases.
- In case of broken or rusty ball bearings
- In case of worn or damaged ball bearings
- When the ball bearings fail to turn smoothly or emit noise in rotation after transmission gear oil has been applied.
- Transfer drive gear
If the tooth face of transfer drive gear and the shaft are excessively broken or damaged, replace the transfer drive gear.
- Measure the clearance between snap ring and inner race of ball bearing with a thickness gauge.
Clearance:
0.01 - 0.15 mm (0.0004 - 0.0059 in)
If the measurement is not within specification, select a suitable snap ring and replace it.
Snap ring (outer-30) Part No. Thickness mm (in) 805030041 1.53 (0.0602) 805030042 1.65 (0.0650) 805030043 1.77 (0.0697)