LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Floor Mat >> Removal

Floor Mat: Removal

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".

    Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

  • Airbag system satellite safing sensor is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  1. Disconnect the ground cable from battery.

    Refer to NOTE>NOTE>BATTERY .

    NOTE:
    • For model with battery sensor, disconnect the ground terminal from battery sensor.
    • On CVT models, shift the select lever into "N" before disconnecting the battery ground cable.
  2. Remove the front seat assembly.

    Refer to SEATS>FRONT SEAT>REMOVAL

  3. Remove the rear seat cushion assembly,

    Refer to SEATS>REAR SEAT>REMOVAL

  4. Remove the console box assembly, the cover - shift lever and the panel center LWR.

    Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .

  5. Remove the lower inner trim on the RH and LH sides.

    Refer to EXTERIOR/INTERIOR TRIM>LOWER INNER TRIM>REMOVAL .

  6. Remove the pull handle cover.

    Refer to SECURITY AND LOCKS>REMOTE OPENERS>REMOVAL>FUEL FLAP .

  7. Remove the knobs of the hook - seat cushion rear.
    G08316014Courtesy of SUBARU OF AMERICA, INC.
  8. Take out the floor mat from the vehicle.
    1. Remove the clips from the floor mat.
    2. Remove the mat hook on both sides.
    3. Take out the floor mat after folding down.
      G08319558Courtesy of SUBARU OF AMERICA, INC.