Clutch Pedal Switch: Installation
WARNING: This page is about a different variant/trim than selected.
- Installation of clutch start switch ASSY
- Install the clutch start switch ASSY to the clutch pedal support SUB-ASSY with the nut.
Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}
- Connect the clutch start switch connector.
- Measure the gap shown in the figure with the clutch pedal fully depressed.
Normal clearance: 3.5 to 4.0 mm {0.138 to 0.157 in}
- Install the clutch start switch ASSY to the clutch pedal support SUB-ASSY with the nut.
- Installation of clutch pedal support SUB-ASSY (refer to INSTALLATION , Step 8)
- Installation of clutch switch ASSY
- Install the clutch switch ASSY to the clutch pedal support SUB-ASSY with the nut.
Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}
- Connect the clutch switch connector.
- Check that a gap is not created when the clutch pedal is not depressed.
- Install the clutch switch ASSY to the clutch pedal support SUB-ASSY with the nut.
- Installation of instrument panel under cover SUB-ASSY No. 1 (refer to INSTALLATION )
- Installation of instrument side panel LH (refer to INSTALLATION , Step 8)
- Check of clutch start system (refer to CLUTCH SYSTEM )