LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transaxle & Differential) >> Manual Transmission Extension Housing Oil Seal >> Replacement

Manual Transmission Extension Housing Oil Seal: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Drain of transmission gear oil (Refer to MANUAL TRANSMISSION OIL )
  2. Removal of propeller shaft with center bearing ASSY (Refer to PROPELLER SHAFT ASSY )
    G08554846Courtesy of SUBARU OF AMERICA, INC.
  3. Removal of transmission extension housing oil seal (MTM)
    1. Use the SST to remove the transmission extension housing oil seal (MTM).

      SST 398527700

  4. Installation of transmission extension housing oil seal (MTM)
    1. Apply a small amount of manual transmission oil to the lip of a new transmission extension housing oil seal (MTM).
      NOTE: Be sure to use the recommended product or the substitute product for manual transmission oil. (Refer to MANUAL TRANSMISSION OIL )
      G12587999Courtesy of SUBARU OF AMERICA, INC.
    2. Use the SST to install the transmission extension housing oil seal (MTM).

      SST 09325-20010

      Standard value: 0.1 to 1.1 mm {0.00394 to 0.0433in} (from end face of extension housing)

      CAUTION:
      • Avoid damage to the lip of the transmission extension housing oil seal (MTM).
      • Be careful not to install the transmission extension housing oil seal (MTM) in the wrong direction.
      • Do not drive in the transmission extension housing oil seal (MTM) excessively.
  5. Installation of propeller shaft with center bearing ASSY (Refer to INSTALLATION )
    CAUTION: Thoroughly wipe away the spilled oil.
scientia non olet · About LEMON Manuals