Propeller Shaft ASSY: Installation
- Installation of propeller shaft W/center bearing ASSY
- Clean and remove oil, etc. completely from the joint of the rear differential flange.
- Remove the SST from the extension housing.
- Insert the propeller shaft W/center bearing ASSY into the extension housing.
- Install the center support bearing bracket of the propeller shaft center bearing ASSY using 2 bolts.
Standard value: T=52N.m {530kgf.cm} {38.4ft.lbf}
- Align the alignment marks on the differential side companion flange and flexible coupling.
- Install with 4 bolts, 4 washers and 4 nuts.CAUTION: Secure the nut and turn the bolt.
Standard value: T=74N.m {755kgf.cm} {54.6ft.lbf}
- Filling of manual transmission oil (Transmission M/T) (Refer to MANUAL TRANSMISSION OIL )
- Inspection of manual transmission oil leakage (Transmission M/T) (Refer to MANUAL TRANSMISSION OIL )
- Filling of automatic transmission fluid (Transmission A/T) (Refer to ADJUSTMENT )
- Adjustment of automatic transmission fluid level (Transmission A/T) (Refer to ADJUSTMENT )
- Installation of exhaust pipe ASSY CTR (Refer to INSTALLATION )