Floor Shift, Shift Lever ASSY: Removal
WARNING: This page is about a different variant/trim than selected.
- Removal of console box ASSY (refer to
REMOVAL
)
- Removal of shift lever boot
- Remove the 2 clips, then remove the insulator.
- Release the clamp and disconnect the wiring harness.
- Remove the 4 bolts, then remove the plate CP and the shift & select lever boot.
- Remove the 2 clips, then remove the insulator.
- Disconnection of floor shift control shaft
- Turn up the shift & select lever boot and remove the clip and the plate washer.
- Disconnect the floor shift control shaft from the lever CP.
- Remove the shift & select lever boot.
- Removal of lever CP
- Remove the 4 bolts, then remove the stopper.
- Remove the lever CP from the floor shift control shift lever retainer.