LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Interior Trim / Instrument Panel >> Front Console Box >> Removal

Front Console Box: Removal

  1. Removal of console box cover FR (with smart key system)
    1. Check that the shift lever is in N position.
    2. Apply protective tape to the location shown in the figure.
      G12594818Courtesy of SUBARU OF AMERICA, INC.
    3. Release the 6 claws and remove the console box cover FR.
      NOTE: While holding the inside of the pocket and the engine ignition switch, pull out the console box cover FR.
      G08555517Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Remove the passenger's side instrument panel finish panel end and remove the console box cover FR, pushing the back of the cover with a stick (tool handle, etc.).
      G12594820Courtesy of SUBARU OF AMERICA, INC.
      CAUTION: Do not push switches or antennas with a stick (tool handle, etc.).
  2. Removal of push button start switch (with smart key system) (Refer to ENGINE SWITCH )
  3. Removal of electrical key antenna (with smart key system) (Refer to ELECTRICAL OSCILLATOR KEY (FOR FRONT FLOOR) )
  4. Removal of console box cover FR (without smart key system)
    1. Check that the shift lever is in N position.
    2. Apply protective tape to the location shown in the figure.
      G12594821Courtesy of SUBARU OF AMERICA, INC.
    3. Release the 6 claws and remove the console box cover FR.
      NOTE:
      • While holding the inside of the pocket, pull out the console box cover FR.
      • If it is difficult to remove the cover, refer to the procedure with smart key system.
      G08555520Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Remove the passenger's side instrument panel finish panel end and remove the console box cover FR, pushing the back of the cover with a stick (tool handle, etc.).
      G12594823Courtesy of SUBARU OF AMERICA, INC.
      CAUTION: Do not push switches or antennas with a stick (tool handle, etc.).
  5. Removal of shift lever knob (transmission A/T)
    1. Turn the shift lever knob in the direction of the arrow in the figure and remove it.
      G08555522Courtesy of SUBARU OF AMERICA, INC.
  6. Removal of console panel SUB-ASSY UPR (transmission A/T)
    1. Release the 2 clips and 4 claws.
    2. Disconnect the connectors and remove the console panel SUB-ASSY UPR.
      G08555523Courtesy of SUBARU OF AMERICA, INC.
  7. Removal of shift position indicator (transmission A/T)
    1. Remove the 2 screws, release the clamp, and remove the shift position indicator.
      G12594826Courtesy of SUBARU OF AMERICA, INC.
  8. Removal of shifting hole cover SUB-ASSY (transmission A/T)
    1. Remove the 2 screws, release the claw, and remove the shifting hole cover SUB-ASSY.
      G12594827Courtesy of SUBARU OF AMERICA, INC.
  9. Removal of pattern select switch ASSY (transmission A/T) (Refer to VSC (VDC) OFF SWITCH )
  10. Removal of shift lever knob (transmission M/T)
    1. Turn the shift lever knob in the direction of the arrow in the figure and remove it.
      G08555526Courtesy of SUBARU OF AMERICA, INC.
  11. Removal of console panel SUB-ASSY UPR (transmission M/T)
    1. Release the 2 clips and 4 claws.
    2. Disconnect the connectors and remove the console panel SUB-ASSY UPR.
      G08555527Courtesy of SUBARU OF AMERICA, INC.
  12. Removal of shifting hole cover SUB-ASSY (transmission M/T)
    1. Remove the 4 screws and remove the shifting hole cover SUB-ASSY.
      G12594830Courtesy of SUBARU OF AMERICA, INC.
  13. Removal of pattern select switch ASSY (transmission M/T) (Refer to VSC (VDC) OFF SWITCH )
  14. Removal of instrument panel cup holder
    1. Remove the instrument panel cup holder.
      G12594831Courtesy of SUBARU OF AMERICA, INC.
  15. Removal of cup holder cushion
    1. Remove the cup holder cushion.
      G12594832Courtesy of SUBARU OF AMERICA, INC.
  16. Removal of parking brake hole cover
    1. Release the 5 claws and remove the parking brake hole cover.
      CAUTION: If the cover is pulled toward you, the claws may be damaged. Be sure to pull the cover upward and remove it.
      G12594833Courtesy of SUBARU OF AMERICA, INC.
  17. Removal of instrument panel finish panel end RH
    1. Release the 4 claws and remove the instrument panel finish panel end RH.
      G12594834Courtesy of SUBARU OF AMERICA, INC.
  18. Removal of instrument panel finish panel end LH
    NOTE: Remove the part in the same manner as RH side.
  19. Removal of console box ASSY
    1. Remove the 4 screws.
      G12594835Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the 2 bolts.
    3. Disconnect the connectors and remove the console box ASSY.
      WARNING: The satellite safing sensor of the airbag system is installed under the rear side of the console box ASSY. Before removing the console box ASSY, always be sure to confirm the precautions related to the SRS airbag system. (Refer to SRS AIRBAG SYSTEM )
      G12594836Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals