Floor Shift, Shift Lever ASSY: Installation

WARNING: This page is about a different variant/trim than selected.

Installation of lever CP
1. Install the lever CP to the floor shift control shift lever retainer.
2. Install the stopper with the 4 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
Courtesy of SUBARU OF AMERICA, INC.
Connection of floor shift control shaft
1. Apply Permalub ECN-9 or equivalent to the tip of the floor shift control shaft.
2. Temporarily install a new shift & select lever boot.
3. Connect the tip of the floor shift control shaft to the lever CP and install the plate washer and the clip, then install the shift & select lever boot.
Reverse check adjustment (refer to ADJUSTMENT )

Courtesy of SUBARU OF AMERICA, INC.
Installation of shift lever boot
1. Install the plate CP and the shift lever boot with the 4 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
  
  CAUTION: Cover the lever CP with the shift lever boot, and install the inner sealing portion to the bottom of the stopper and the upper sealing portion to the groove on the bottom of the slider.
2. Connect the harness.
3. Install the insulator with the 2 clips.
Installation of console box (refer to INSTALLATION )