Floor Shift, Shift Lever ASSY: Adjustment

WARNING: This page is about a different variant/trim than selected.

Courtesy of SUBARU OF AMERICA, INC.

Reverse check adjustment

Insert a shim that is 1.0 mm {0.0394 in} in thickness between the detent and the stopper, and push the stopper to the detent.

STANDARD VALUE SPECIFICATION

Part	Dimension
a	1.0mm {0.0394in}

Tighten the 4 flange bolts on the stopper.
Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
Check that shift operation of 1st-2nd can be performed.
If shift operation of 1st-2nd cannot be performed in the above check, perform the steps (1) to (4) with a shim that is 0.2 mm {0.0079 in} thinner.
Check that shift operation of 1st-2nd can be performed.
After the completion of reverse check adjustment, apply NIG-TIGHT LYW No. 2 or equivalent to the detent and the stopper.

Courtesy of SUBARU OF AMERICA, INC.