On-Vehicle Inspection
NOTE:
- The following procedure is for LH side.
- Perform the same procedures for the RH and LH side.
- Removal of rear tire
- Disconnection of rear disc brake caliper ASSY LH (Refer to DISASSEMBLY )
- Removal of rear disc (Refer to
REMOVAL (BREMBO TYPE)
)
- Inspection of rear axle hub & bearing ASSY axial play
- Inspect axial play of the bearing near the axle hub inner periphery (flange portion) using a dial gauge.
Limit: 0.05mm {0.00196in}
CAUTION: If it exceeds the limit, replace the rear axle hub & bearing ASSY with a new part.
- Inspect axial play of the bearing near the axle hub inner periphery (flange portion) using a dial gauge.
- Inspection of rear axle hub & bearing ASSY runout
- Inspect runout of the bearing near the axle hub outer periphery using a dial gauge.
Limit: 0.05mm {0.00196in}
CAUTION: If it exceeds the limit, replace the rear axle hub & bearing ASSY with a new part.
- Inspect runout of the bearing near the axle hub outer periphery using a dial gauge.
- Installation of rear disc (Refer to INSTALLATION (BREMBO TYPE) )
- Connection of rear disc brake caliper ASSY LH (Refer to PARKING BRAKE SWITCH ASSY )
- Installation of rear tire
Standard value: T=120N.m {1224kgf.cm} {88.5fft.lbf}