Power Window Regulator Motor ASSY (Installed To The Front Side): Installation
NOTE:
The following procedure is for LH side. Perform the same procedures both for the LH side and RH side, unless otherwise specified.
- Installation of power window regulator motor ASSY LH
- Using Torx socket wrench T25, with the 3 Torx screws, install the power window regulator motor ASSY LH onto the front door window regulator LH.
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Using Torx socket wrench T25, with the 3 Torx screws, install the power window regulator motor ASSY LH onto the front door window regulator LH.
- Installation of front door window regulator W/motor ASSY (Refer to ASSEMBLY )
- Installation of the front door frame SUB-ASSY RR LWR LH (Refer to ASSEMBLY )
- Installation of front door glass SUB-ASSY LH (Refer to ASSEMBLY )
- Adjustment of the front door glass SUB-ASSY LH
- Installation of the front door service hole cover LH (Refer to ASSEMBLY )
- Installation of power window regulator master switch ASSY W/front armrest base panel UPR LH (driver's side door) (Refer to ASSEMBLY )
- Installation of power window regulator switch ASSY W/front armrest base panel UPR RH (passenger's side door) (Refer to ASSEMBLY )
- Installation of the front door trim board SUB-ASSY LH (Refer to ASSEMBLY )
- Installation of the door armrest cover LH (Refer to ASSEMBLY )
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Power window registration settings (Refer to REGISTRATION SETTINGS )
- Function inspection of the power windows (Refer to UNIT INSPECTION )