LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Rear Bumper >> Installation

Rear Bumper: Installation

  1. Installation of the rear bumper cover
    1. Preparations for installation
      1. Pull the wiring harness of the back-up light ASSY in to the interior.
    2. In the direction of the arrow in the figure, insert the 3 guides.
      G12595414Courtesy of SUBARU OF AMERICA, INC.
    3. Securely align two cutout portions on the rear bumper.
      • The positioning rib on the rear bumper side bracket
      • The positioning rib on the rear bumper side retainer
      G08558042Courtesy of SUBARU OF AMERICA, INC.
    4. Fit in the 3 claws.
      NOTE: Perform same procedures for the RH side.
      G10217835Courtesy of SUBARU OF AMERICA, INC.
    5. Fit in the 5 claws.
      NOTE: Perform same procedures for the RH side.
      G11263111Courtesy of SUBARU OF AMERICA, INC.
    6. Install the 2 screws.
      G08558022Courtesy of SUBARU OF AMERICA, INC.
    7. Using 8 clips, install the rear bumper cover.
      G08558024Courtesy of SUBARU OF AMERICA, INC.
      G12595420Courtesy of SUBARU OF AMERICA, INC.
    8. Connect the connector.
    9. Using a clamp, install the wiring harness of the back-up light ASSY.
  2. Installation of the trunk trim cover INN LH (Refer to INSTALLATION , Step 2)
  3. Installation of the trunk side tray LH
  4. Installation of the rear floor finish plate (Refer to INSTALLATION , Step 3)
  5. Installation of the trunk floor mat
scientia non olet · About LEMON Manuals