Rear Combination Light: Installation

NOTE: The following procedure is for LH side. Perform the same procedures for the RH and LH side.

Installation of the rear combination light ASSY LH

Tighten the 4 nuts from? to? to install the rear combination light ASSY LH.

NOTE: The RH side is mirrored.

Standard value: T=4.5N.m {46kgf.cm} {3.3ft.lbf}

Courtesy of SUBARU OF AMERICA, INC.

Using 2 grommets, install the rear combination light socket & wiring SUB-ASSY LH.
Connect the connector.

Installation of the trunk trim cover INN LH
1. Using 5 clips, install the trunk trim cover INN LH.
Installation of the rear floor finish plate
1. Fit in the 4 tabs, and using 3 clips, install the rear floor finish plate.
Installation of the trunk floor mat