LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag System (Diagnostics) >> SRS Airbag System >> DTC B1831: Open In Curtain Airbag RH Squib Circuit >> Inspection steps

Inspection steps

CAUTION: Before performing the diagnosis, refer to the PRECAUTIONS .
  1. Check poor contact of connectors.
    1. Check for poor contact of the connectors between the airbag control module and the curtain airbag module.

    Criteria: No fault is found.

    NG: Replace the airbag rear harness along with the body harness.

    OK: Go to next step

  2. Check curtain airbag module.
    G12589817Courtesy of SUBARU OF AMERICA, INC.
    1. Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
    2. Disconnect the connector (G11) from the curtain airbag module RH.
    3. Connect the connector (1N) in the test harness N to the connector C.
    4. Connect the airbag resistor to the connector (2N) in the test harness N.
    5. Connect the battery ground terminal and turn the ignition switch to ON.

    Criteria: Airbag warning light remains on even after 6 seconds have passed.

    NG: Replace the curtain airbag module.

    OK: Go to next step

  3. Check airbag rear harness (curtain airbag module harness RH).
    G12589818Courtesy of SUBARU OF AMERICA, INC.
    1. Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
    2. Disconnect the connector (G17) from the seat belt pretensioner RH.
    3. Disconnect the connector (Gc1) from the side airbag module RH.
    4. Disconnect the airbag resistor from the connector (2N) in the test harness N.
    5. Disconnect the connector (D27, G19, H32) from the airbag control module, and connect the connector (1AG) in the test harness AG.
    6. Measure the resistance between the terminals.
    STANDARD VALUE RESISTANCE SPECIFICATION

    Inspection terminals Inspection conditions Standard value
    (6AG) No. 8 - (2N) No. 2 Always Less than 10 Ω
    (6AG) No. 6 - (2N) No. 1 Always Less than 10 Ω

    NG: Replace the airbag rear harness along with the body harness.

    OK: Go to next step

  4. Check DTC
    1. Connect all connectors.
    2. Clear the memory.
    3. Perform the reproduction procedure.
    4. Read the DTC. (Current malfunction)

    Criteria: DTC B1831 is not displayed.

    NG: Replace the airbag control module.

    OK: Go to next step

  5. Check DTC

    Criteria: No other DTC is displayed.

    NG: Perform diagnosis for the displayed DTC.

    OK: Go to next step

    Complete

scientia non olet · About LEMON Manuals