LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag System (Diagnostics) >> SRS Airbag System >> DTC B1806: Open In Passenger's Airbag >> Inspection steps

Inspection steps

CAUTION: Before performing the diagnosis, refer to the PRECAUTIONS .
  1. Check poor contact of connectors.
    1. Check for poor contact of the connectors between the airbag control module and the passenger's airbag module.

    Criteria: No fault is found.

    NG: Replace the airbag main harness along with the body harness.

    OK: Go to next step

  2. Check airbag main harness (passenger's airbag harness).
    G12589739Courtesy of SUBARU OF AMERICA, INC.
    1. Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
    2. Remove the column cover and disconnect the connector (D52).
    3. Disconnect the passenger's airbag module connector (D30).
    4. Disconnect the connector (D27, G19, H32) of the airbag control module.
    5. Using a probe, measure the resistance between the terminals of connector (D30).
    CAUTION: When measuring the resistance, make sure that the probe is inserted from the back side (harness side) of the connector. Also, do not insert the probe forcibly.
    STANDARD VALUE RESISTANCE SPECIFICATION

    Inspection terminals Inspection conditions Standard value
    (D30) No. 1 - (D30) No. 2 Always Less than 10 Ω

    Criteria: Airbag warning light remains on even after 6 seconds have passed.

    NG: Replace the airbag main harness along with the body harness.

    OK: Go to next step

  3. Check DTC
    G12589740Courtesy of SUBARU OF AMERICA, INC.
    1. Connect the connector (D27, G19, H32) to the airbag control module.
    2. Connect the connector (D52).
    3. Using a probe, short-circuit the terminals 1 to 2 of the connector C.
      CAUTION: When short-circuiting the terminals, make sure that the probe is inserted from the back side (harness side) of the connector. Also, do not insert the probe forcibly.
    4. Connect the battery ground terminal and turn the ignition switch to ON.
    5. Perform the reproduction procedure.
    6. Read the DTC. (Current malfunction)

    Criteria: DTC B1806 is not displayed.

    NG: Replace the airbag control module.

    OK: Go to next step

  4. Check passenger's airbag module.
    G12589741Courtesy of SUBARU OF AMERICA, INC.
    1. Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
    2. Connect the passenger's airbag module connector (D30).
    3. Connect the battery ground terminal, and clear the memory.
    4. Perform the reproduction procedure.
    5. Read the DTC. (Current malfunction)

    Criteria: DTC B1806 is not displayed.

    NG: Replace the passenger's airbag module.

    OK: Go to next step

  5. Check DTC

    Criteria: No other DTC is displayed.

    NG: Perform diagnosis for the displayed DTC.

    OK: Go to next step

    Complete

scientia non olet · About LEMON Manuals