Inspection steps

CAUTION: Before performing the diagnosis, refer to the PRECAUTIONS .

CAN communication system check
1. Check CAN communication system. (Refer to HOW TO TROUBLESHOOT )
  Criteria: No fault is found.
NG: Repair it according to the diagnosis by the CAN communication system.

OK: Go to next step
Connector check
1. Turn the ignition switch to OFF, disconnect the battery ground terminal, and wait for 60 seconds or more.
2. Check the connection status of airbag Control Module connector.
  Criteria: No fault is found.
NG: Repair the connector.

OK: Go to next step
Combination meter check
1. Check the combination meter.
  Criteria: No fault is found.
NG: Repair or replace the combination meter.

OK: Go to next step

Replace the airbag Control Module.