LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Glove Box >> Removal

Glove Box: Removal

NOTE: Refer to "Security and Locks" information for key cylinder replacement. Ref. to SECURITY AND LOCKS>Key Lock Cylinders>REPLACEMENT>GLOVE BOX LID .
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the pocket assembly.
    1. Remove the damper COMPL - pocket.
    2. Release the stoppers and remove the pocket assembly by pulling it toward you.
      G10272967Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the cover side sill - front and the front cover - side sill. Ref. to EXTERIOR/INTERIOR TRIM>Lower Inner Trim>REMOVAL .
  4. Remove the back panel - pocket.
    1. Release the hook, and remove the under cover assembly - passenger.
      G10276787Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the clips, and remove the cover - instrument panel side RH.
    3. Release the clips, and remove the ornament - panel assembly passenger.
      G10273130Courtesy of SUBARU OF AMERICA, INC.
    4. Disconnect the glove box light LED connector.
    5. Remove the screws, claws and harness clamp, then remove the back panel - pocket.
      G10273131Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals