LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Continuously Variable Transaxle (CVT) (H6DO)) >> Transmission Mounting System >> Removal >> Transmission Rear CROSSMEMBER And Rear Cushion Rubber

Transmission Rear CROSSMEMBER And Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Ref. to BATTERY
    NOTE: Repair Contents.
  2. Lift up the vehicle.
  3. Remove the front exhaust pipe. Ref. to REMOVAL , Front Exhaust Pipe.
  4. Remove the center exhaust cover.
    Fig 1: Identifying Center Exhaust Cover
    G10274676Courtesy of SUBARU OF AMERICA, INC.
  5. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
  6. Remove the transmission rear crossmember.
    Fig 2: Identifying Transmission Rear Crossmember Bolts
    G10276002Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the rear cushion rubber.
    Fig 3: Identifying Rear Cushion Rubber Bolts
    G09481952Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals