LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Legacy 2.5i Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Emission Control Systems (Aux. Emission Control Devices) (H6DO)) >> EGR Control Valve >> Installation

EGR Control Valve: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the EGR control valve, and connect the connector to the EGR control valve.
    NOTE: Use a new gasket.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb) 

  2. Install the EGR pipe A. <Ref. to EGR PIPE A , INSTALLATION, EGR Pipe.>
  3. Install the air intake boot. <Ref. to INSTALLATION , Air Intake Boot.>
  4. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About LEMON Manuals