DTC P2769 Torque Converter Clutch Circuit Low: Notes

DTC detecting condition: 

Immediately at fault recognition

Trouble symptom: 

No lock-up occurs.

Wiring diagram: 

CVT control system Ref. to WIRING SYSTEM>CVT Control System>WIRING DIAGRAM>TURBO MODEL .

1. CHECK HARNESS. 
   1. Turn the ignition switch to OFF.
   2. Disconnect the TCM connector.
   3. Disconnect the transmission connector.
   4. Measure the resistance between TCM connector and chassis ground.

      Connector & terminal 

      (B54) No. 31 - Chassis ground:

   Is the resistance 1 MΩ or more?

   • Yes  : Go to 2. 
   • No  : Repair the short circuit of harness.
2. CHECK LOCK UP ON/OFF SOLENOID. 

   Measure the resistance between transmission connector and transmission body.

   Connector & terminal 

   (T4) No. 3 - Transmission body:

   Is the resistance approximately 13 - 18.5 Ω? (when cold)

   • Yes  : Check for poor contact of connector, and if no fault is found, replace the TCM. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Transmission Control Module (TCM) .
   • No  : Go to 3. 
3. CHECK HARNESS INSIDE TRANSMISSION. 
   CAUTION: Start work after ATF cools down.
   1. Remove the transmission oil pan.
   2. Check for the harness pinch, damage.

   Is there any fault in the harness?

   • Yes  : Replace the transmission harness.
   • No  : Go to 4. 
4. CHECK HARNESS INSIDE TRANSMISSION. 
   1. Disconnect the control valve body connector.
   2. Measure the resistance between transmission connector and transmission body.

      Connector & terminal 

      (T4) No. 3 - Transmission body:

   Is the resistance 1 MΩ or more?

   • Yes  : Replace the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR690)>Control Valve Body .
   • No  : Replace the transmission harness.