LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Roll Connector >> Installation

Roll Connector: Installation

CAUTION: If the steering wheel and steering angle sensor are removed, perform "VSC(VDC) Centering Mode" of the VDC.
  • Align the center position of the steering roll connector.
  • Perform the neutral position setting of the steering angle sensor.
  1. Before attaching a new roll connector, apply a thin coat of grease contained in the connector onto the areas shown by the arrows.
    Fig 1: Locating Roll Connector Grease Applying Areas
    G08316425Courtesy of SUBARU OF AMERICA, INC.
  2. Install each part in the reverse order of removal.
  3. Be sure to adjust the direction of roll connector with steering. Ref. to AIRBAG SYSTEM>Roll Connector>ADJUSTMENT .
  4. Install the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>SteeringWheel>INSTALLATION .
  5. Install the driver's airbag module. Ref. to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION .
  6. Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
  7. Perform the neutral position setting of the steering angle sensor. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
scientia non olet · About LEMON Manuals