HVAC System (Heater, Ventilator And A/C): Condenser: Installation

CAUTION:

If the condenser assembly - air conditioner has been replaced, add an appropriate amount of compressor oil. Ref. to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>Compressor Oil>ADJUSTMENT .
Replace the O-rings with new parts, and then apply compressor oil.

Install each part in the reverse order of removal.

NOTE: To tighten the bolts at the bottom of the condenser, use the SPECIAL TOOL CONDENSER (ST).

Preparation tool:

ST: SPECIAL TOOL CONDENSER (73099SG000)

Tightening torque:

Radiator upper bracket: 12 N.m (1.22 kgf-m, 8.9 ft-lb)

Condenser (bolts at the bottom)

Calculation formula
T = L/(100 mm (3.94 in)+L) x7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
T: Tightening torque
L: Effective length of torque wrench
NOTE: If the effective length of the torque wrench used is unknown, consult the manufacturer of the torque wrench.

Fig 1: Tightening Condenser Bottom Bolts Using Special Tool

Courtesy of SUBARU OF AMERICA, INC.

Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
Charge refrigerant. Ref. to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>Refrigerant Charging Procedure>PROCEDURE .