EGR Control Valve: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the EGR pipe adapter to the EGR control valve.NOTE: Use a new gasket.
Tightening torque:
19 N.m (1.9 kgf-m, 14.0 ft-lb)
- Install the EGR control valve to the intake manifold assembly, and connect the connector to the EGR control valve.
Tightening torque:
19 N.m (1.9 kgf-m, 14.0 ft-lb)
- Install the bolts securing the EGR cooler to the EGR control valve.NOTE: Use a new gasket.
Tightening torque:
T1: 9 N.m (0.9 kgf-m, 6.6 ft-lb)
- Tighten the bolts holding the EGR cooler to the cylinder head RH.
Tightening torque:
T2: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Install the EGR pipe. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>EGR Pipe>INSTALLATION .
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Boot>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to NOTE>NOTE>BATTERY .