Water Pipe Assembly RH

WARNING: This page is about a different variant/trim than selected.

Set the water pipe assembly RH on the engine, and connect the water pipe hose RH (B) to the oil pan upper.
Secure the water pipe assembly RH to the cylinder head RH with bolt (A).
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 1: Identifying Water Pipe Hose (RH) And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the bolt (B) which secures the water pipe assembly RH to the cam carrier RH.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Connect the water hose (A) to the water pipe assembly RH.

Fig 2: Identifying Water Hose And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the front exhaust pipe. Ref. to EXHAUST(H4DO)>Front Exhaust Pipe>INSTALLATION .
Lower the vehicle.
Connect the ground terminal to battery sensor. Ref. to NOTE>NOTE>BATTERY .
Fill engine coolant. Ref. to COOLING(H4DO)>Engine Coolant>REPLACEMENT>FILLING OF ENGINE COOLANT .