DTC P2005 TGV Control Stuck Open Bank 2: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Immediately at fault recognition

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode>OPERATION . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Inspection Mode>PROCEDURE .

CHECK FOR ANY OTHER DTC ON DISPLAY .
Is any other DTC displayed?
- Yes: Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>List of Diagnostic Trouble Code (DTC) .
- No: Go to 2.
CHECK TUMBLE GENERATOR VALVE LH .
1. Remove the tumble generator valve assembly LH.
2. Check the tumble generator valve.
Is there any dirt or clogging with foreign objects in the tumble generator valve?
- Yes: Clean the tumble generator valve.
- No: Replace the tumble generator valve LH. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Tumble Generator Valve .