DTC P081A Starter Disable Circuit Low: Notes

WARNING: This page is about a different variant/trim than selected.

Immediately at fault recognition

Trouble symptom:

Failure of engine to start

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Clear Memory Mode . and Inspection Mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>Inspection Mode .
Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM>Engine Electrical System>WIRING DIAGRAM .

Fig 1: Engine Electrical System Wiring Diagram (Starter Disable Circuit Low)

G11272672

Courtesy of SUBARU OF AMERICA, INC.

CHECK HARNESS BETWEEN STARTER RELAY (PUSH BUTTON START) CONNECTOR AND STARTER CUT RELAY CONNECTOR .
1. Turn the ignition to OFF.
2. Remove the starter relay (push button start).
3. Remove the starter cut relay.
4. Measure the resistance of harness between starter relay (push button start) connector and starter cut relay connector.
Connector & terminal

(B225) No. 28 - (B225) No. 42:

Is the resistance less than 1 Ω?
- Yes: Go to 2.
- No: Repair the open circuit in harness between starter relay (push button start) connector and starter cut relay connector.
CHECK HARNESS BETWEEN ECM AND STARTER CUT RELAY CONNECTOR .
1. Disconnect the connector from ECM.
2. Measure the resistance of harness between ECM connector and starter cut relay connector.
Connector & terminal

(B134) No. 49 - (B225) No. 40:

Is the resistance less than 1 Ω?
- Yes: Go to 3.
- No: Repair the open circuit of harness between ECM connector and starter cut relay connector.
CHECK STARTER CUT RELAY .

Connect the battery to starter cut relay terminals No. 40 and No. 42.
Measure the resistance between starter cut relay terminals.

Terminals

No. 41 -No. 44:

Is the resistance 1 MΩ or more?

Yes: Repair the poor contact of ECM connector.
No: Replace the starter cut relay. Ref. to SECURITY AND LOCKS>Starter Cut Relay .