Engine Mechanical (H4DOTC): V-belt: Removal: V-Belt

1. When working on the vehicle
   NOTE: When working on the vehicle, perform the following steps also.
   1. Remove the collector cover.
      1. Remove the clip (A).
      2. Hold the shaded area (B) by hand and carefully pull the RH side (C) upward.
      3. Hold the shaded area (D) by hand and carefully pull the LH side (E) upward.
      Fig 1: Removing Collector Cover

      Courtesy of SUBARU OF AMERICA, INC.
   2. Remove the air intake duct (rear). Ref. to INTAKE (INDUCTION) (H4DOTC)>Air Intake Duct>REMOVAL .
2. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to loosen and remove the V-belt.

Fig 2: Rotating Tool Clockwise

Courtesy of SUBARU OF AMERICA, INC.