LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> Forester 2.0XT Touring >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats >> Seat Heater System >> Installation >> Seat Heater Module - Front

Seat Heater Module - Front

  1. Affix the seat heater module - front to the pad assembly.
    CAUTION:
    • If the cover - front cushion is removed, make sure to replace the hang wire on the cover front cushion side with a new wire.
    • When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the hog ring.
    • When removing or replacing the seat cover, perform "Occupant Detection System Inspection" after installing the seat to check if the occupant detection system operates normally. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>SEAT .
    • If the seat heater module is removed, replace the seat cushion pad & frame assembly with a new part. (Passenger's seat)
    • If the seat heater module is reused, remove the polyurethane section from the reverse side completely.

      Preparation items: 

      Double-sided tape: NITTO DENKO 501L or equivalent

  2. Assemble the front seat. Ref. to SEATS>Front Seat>ASSEMBLY .
  3. Install the front seat assembly. Ref. to SEATS>Front Seat>INSTALLATION .
  4. Install the battery sensor to the ground terminal. Ref. to NOTE>NOTE>BATTERY .
scientia non olet · About LEMON Manuals