Turn Signal Light & Hazard Light Unit: Removal

CAUTION: Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>NOTE>BATTERY .
   NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
2. Remove the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
3. Remove the knee airbag module. Ref. to AIRBAG SYSTEM>Knee Airbag Module>REMOVAL .
4. Remove the turn signal & hazard unit.
   1. Disconnect the connector.
   2. Release the claws and remove the turn signal & hazard unit from the beam COMPL - steering.

Fig 1: Locating Turn Signal And Hazard Unit Connector

Courtesy of SUBARU OF AMERICA, INC.