Adjustment Value Clear

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. On the work support item list, select [Clear adjustment value].
2. When [Make the following adjustment/inspection. Please push OK if ready. CAUTION! - Please confirm because the chart position height differs according to the model (vehicle height). - Set the ignition switch to OFF after press Cancel at the end of adjustment/inspection mode.] is displayed, select [OK] if preparation is ready.
3. After [Clear the adjustment value. CAUTION! Perform this only under the conditions listed in the service manual.] is displayed, select [OK].
4. When [Clearing adjustment value...] is displayed, wait until it finishes.
5. When the adjustment value clear is finished correctly, and [Adjustment value cleared OK! Adjustment value clearing has been completed normally.] is displayed, select [OK] to finish.
6. Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
   CAUTION: If the ignition switch OFF period is short, the adjustment value clear can not be performed correctly.
7. Next, perform the camera all adjustment mode (replacement/removal). Ref. to EyeSight>Camera Adjustment, Inspection>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .