LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> WRX Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle & Differential (TY85) (WRX-STI)) >> Transfer Drive Gear >> Installation

Transfer Drive Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transfer drive gear.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

  2. When the ball bearing, transfer drive gear or snap ring are replaced, select an appropriate adjusting washer for the transfer drive gear. < Ref. to ASSEMBLY , Extension Cases. >
  3. Install the extension case. < Ref. to INSTALLATION , Extension Cases. >
  4. Install the manual transmission assembly to the vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals