Stop Light Switch: Removal

CAUTION: Before performing service on the airbag module, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" section. < Ref. to CAUTION , General Description. >

Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Note. >
NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
Remove the knee airbag module. < Ref. to REMOVAL , Knee Airbag Module. >
Remove the cover assembly - instrument panel LWR driver. < Ref. to REMOVAL , Instrument Panel Lower Cover. >
Remove the stop light switch.
1. Disconnect the stop light switch connector.
2. Remove the stop light switch by turning it counterclockwise.
  
  Fig 1: Removing Stop Light Switch
  Courtesy of SUBARU OF AMERICA, INC.