LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Crosstrek Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Hybrid Electric Vehicle System (Diagnostics) (Hybrid)) >> Drive Cycle >> Procedure >> Drive Cycle D >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare for drive cycle. < Ref. to PREPARATION FOR DRIVE CYCLE , PROCEDURE, Drive Cycle.>
  2. Set the shift lever to "D" range.
  3. At standing still (vehicle speed is at 0 km/h (0 MPH)), depress the brake pedal several times ON ←→ OFF from Auto Start Stop, then start the engine.
  4. Read the readiness code and check that the concerned DTC is not displayed. < Ref. to ALL READINESS DIAGNOSTIC CODE(S) .>
    NOTE: If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete. Repeat from step  1).
  5. Read the DTC and check that the DTC is not displayed. < Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .> After repairing the cause of setting DTC, repeat from preparation for drive cycle. < Ref. to PREPARATION FOR DRIVE CYCLE , PROCEDURE, Drive Cycle.>
scientia non olet · About LEMON Manuals