LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Crosstrek Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Intake System (Induction) (Hybrid)) >> Intake Duct >> Removal

Intake Duct: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch to OFF.
  2. Remove the collector cover.
    1. Carefully pull up the front of collector cover at two positions (A).
    2. Carefully pull up the rear of collector cover at two positions (B) while moving it backward.
      NOTE: Be careful not to contact the fuel delivery tube when moving the collector cover rearward.
      Fig 1: Removing Collector Cover
      G09486016
  3. Remove the air intake boot No. 1. < Ref. to AIR INTAKE BOOT NO. 1 , REMOVAL, Air Intake Boot. >
  4. Remove the bolt (A) which holds the intake duct to the intake manifold.
  5. Remove the intake duct from the air cleaner case front and the protrusion (B) on the intake manifold protector RH.
    NOTE: When removing the intake duct, check the cushion (a) of the intake duct for peel-off or misalignment.
    Fig 2: Identifying Protrusion On Intake Manifold Protector RH
    G09487305
scientia non olet · About LEMON Manuals