LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2016 >> Crosstrek Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Intake System (Induction) (Hybrid)) >> Air Intake Boot >> Removal >> Air Intake Boot No. 1

Air Intake Boot No. 1

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch to OFF.
  2. Remove the collector cover.
    1. Carefully pull up the front of collector cover at two positions (A).
    2. Carefully pull up the rear of collector cover at two positions (B) while moving it backward.
      NOTE: Be careful not to contact the fuel delivery tube when moving the collector cover rearward.
      Fig 1: Removing Collector Cover
      G09486016
  3. Remove the air intake duct. < Ref. to REMOVAL , Air Intake Duct. >
  4. Remove the air intake boot No. 1 from the protrusion (A) on the intake duct.
    Fig 2: Removing Air Intake Boot No. 1 From Protrusion On Intake Duct
    G09487295
scientia non olet · About LEMON Manuals