Extension Housing Rear Oil Seal: Replacement

(Refer to PROPELLER SHAFT Assembly )

1. Use SST to remove the transmission extension housing oil seal (ATM).

   SST 398527700

   Fig 1: Removing Transmission Extension Housing Oil Seal (ATM)

   Courtesy of SUBARU OF AMERICA, INC.

1. Apply a small amount of auto fluid WS to the lip of a new transmission extension housing oil seal (ATM).
2. Use SST and a hammer to drive in the transmission extension housing oil seal (ATM) in the extension housing.

   SST 09325-40010

   Drive-in depth: 5.4 to 5.8 mm {0.213 to 0.228 in} (from end face of extension housing)

   CAUTION:

   • Keep the lip from foreign substances such as dirt.
   • Be careful not to mistake the installing direction of the transmission extension housing oil seal (ATM).
   Fig 2: Driving Transmission Extension Housing Oil Seal (ATM) Into Extension Housing

   Courtesy of SUBARU OF AMERICA, INC.

(Refer to INSTALLATION )