Propeller Shaft Assembly: Installation

Installation of propeller shaft W/ center bearing assembly
1. Clean and remove oil, etc. completely from the joint of the rear differential flange.
2. Remove the SST from the extension housing.
3. Insert the propeller shaft W/ center bearing assembly into the extension housing.
4. Install the center support bearing bracket of the propeller shaft center bearing assembly using 2 bolts.
  Standard value: T=52N.m {530kgf.cm} {38.4ft.lbf}
  
  Fig 1: Locating Propeller Shaft Center Bearing Assembly Bolts
  Courtesy of SUBARU OF AMERICA, INC.
5. Align the alignment marks on the differential side companion flange and flexible coupling.
  
  Fig 2: Locating Alignment Marks And Bolts
  Courtesy of SUBARU OF AMERICA, INC.
6. Install with 4 bolts, 4 washers and 4 nuts.
  CAUTION: Secure the nut and turn the bolt.
  Standard value: T=74N.m {755kgf.cm} {54.6ft.lbf}
Filling of manual transmission oil (Transmission M/T) (Refer to MANUAL TRANSMISSION OIL )
Inspection of manual transmission oil leakage (Transmission M/T) (Refer to MANUAL TRANSMISSION OIL )
Filling of automatic transmission fluid (Transmission A/T) (Refer to SPEED SENSOR )
Adjustment of automatic transmission fluid level (Transmission A/T) (Refer to SPEED SENSOR )
Installation of exhaust pipe assembly CTR (Refer to INSTALLATION )