LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (STI)) >> Valve Clearance >> Adjustment

Valve Clearance: Adjustment

WARNING: This page is about a different variant/trim than selected.
  1. Measure all the valve clearances. <Ref. to INSPECTION , Valve Clearance.>
    NOTE: Record the measured value of each valve clearance.
    Fig 1: Measuring Valve Clearances
    G04998618Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the camshaft. <Ref. to REMOVAL , Camshaft.>
  3. Remove the valve lifter.
  4. Measure the thickness of valve lifter using micrometer.
    Fig 2: Measuring Valve Lifter Thickness Using Micrometer
    G04998619Courtesy of SUBARU OF AMERICA, INC.
  5. Select a valve lifter of suitable thickness using the measured valve clearance and valve lifter thickness, and install it.
    NOTE: Use a new valve lifter.
    Unit: mm (in)
    Intake valve: S = (V + T) - 0.19 (0.0075)
    Exhaust valve: S = (V + T) - 0.35 (0.0138)
    S: Valve lifter thickness required
    V: Measured valve clearance
    T: Valve lifter thickness to be used
  6. Install the camshaft. <Ref. to INSTALLATION , Camshaft.>
  7. Install the cam sprocket. <Ref. to INSTALLATION , Cam Sprocket.>
  8. Install the timing belt. <Ref. to TIMING BELT , INSTALLATION, Timing Belt.>
  9. Measure all valves for valve clearance again at this time. If the valve clearance is not within the adjustment value, repeat the procedure over again from step  2.

    Valve clearance (adjustment value): 

    Intake 

    0.20 +0.01 -0.03  mm (0.0079 +0.0004 -0.0012  in) 

    Exhaust 

    0.35±0.02 mm (0.0138±0.0008 in) 

  10. After adjustment, install the related parts in the reverse order of removal.
scientia non olet · About LEMON Manuals