LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle & Differential (TY75) (W/O STI)) >> Transfer Drive Gear >> Installation

Transfer Drive Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transfer drive gear.

    Tightening torque: 

    26 N.m (2.7 kgf-m, 19.2 ft-lb) 

    Fig 1: Installing Transfer Drive Gear
    G08581974Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer driven gear. <Ref. to INSTALLATION , Transfer Driven Gear.>
  3. Select the adjusting washer. <Ref. to INSTALLATION , Transfer Case and Extension Case Assembly.>
  4. Install the extension case assembly. <Ref. to INSTALLATION , Transfer Case and Extension Case Assembly.>
  5. Install the transfer case and the extension case assembly. <Ref. to INSTALLATION , Transfer Case and Extension Case Assembly.>
  6. Install the back-up light switch and the neutral position switch. <Ref. to INSTALLATION , Switches and Harness.>
  7. Install the manual transmission assembly to the vehicle. <Ref. to INSTALLATION , Manual Transmission Assembly.>
scientia non olet · About LEMON Manuals