LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle & Differential (TY75) (W/O STI)) >> Front Differential Assembly >> Removal

Front Differential Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission assembly from the vehicle. <Ref. to REMOVAL , Manual Transmission Assembly.>
  2. Remove the transfer case together with the extension case assembly. <Ref. to REMOVAL , Transfer Case and Extension Case Assembly.>
  3. Remove the transmission case. <Ref. to REMOVAL , Transmission Case.>
  4. Remove the drive pinion shaft assembly. <Ref. to REMOVAL , Drive Pinion Shaft Assembly.>
  5. Remove the main shaft assembly. <Ref. to REMOVAL , Main Shaft Assembly for Single-Range.>
  6. Remove the front differential assembly.
    NOTE:
    • Do not confuse the right and left taper roller bearing outer races.
    • Be careful not to damage the oil seal of differential side retainer.
    Fig 1: Removing Front Differential Assembly
    G08318991Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the differential side retainers using ST.

    ST 18630AA010 WRENCH COMPL RETAINER

    Fig 2: Removing Differential Side Retainers Using ST
    G09482650Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the taper roller bearing outer race from the transmission case.

    ST 398527700 PULLER ASSY

scientia non olet · About LEMON Manuals