LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2015 >> WRX Limited, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transaxle & Differential (TY85) (STI)) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the transmission under cover.
  4. Remove the center exhaust pipe. <Ref. to REMOVAL , Center Exhaust Pipe.>
  5. Remove the rear exhaust pipe and muffler. <Ref. to REMOVAL , Rear Exhaust Pipe.> <Ref. to REMOVAL , Muffler.>
  6. Remove the heat shield cover.
  7. Set the transmission jack under the transmission case.
    CAUTION: Always support the transmission case with a transmission jack.
  8. Remove the front crossmember and the rear crossmember.
    Fig 1: Locating Front/Rear Crossmember Bolts
    G10268966Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals