Combination Meter ASSY: Installation

Installation of the combination meter ASSY
1. Connect the connector.
2. Engage two clips and install the combination meter ASSY.
3. Install the 2 screws.
Installation of the instrument panel meter ornament UPR (Refer to INSTALLATION )
Installation of the meter hood SUB-ASSY (Refer to INSTALLATION )
Installation of instrument cluster finish panel SUB-ASSY CTR (Refer to INSTALLATION )
Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )