Instrument Panel LWR: Installation

1. Engage the 14 claws and connect the connectors and clamps.
2. Connect the aspirator hose. (Automatic air conditioning system)
3. Install the 2 screws and nuts.
4. With the 7 screws, install the instrument panel SUB-ASSY LWR.

1. Engage the claw and install the glove compartment door damper.

1. Engage the 2 hinges of the glove compartment door ASSY horizontally.
2. Engage the 2 stoppers and install the glove compartment door ASSY.
   CAUTION:

   If the stoppers are engaged from above, the hinges may be loosened. Always engage them horizontally.

3. Engage the claw and install the glove compartment door damper.

1. Connect the connector.
2. Engage the 2 claws connecting the instrument panel meter ornament UPR to the steering column cover.
3. Engage the 2 clips and 6 claws and install the instrument panel meter ornament UPR.

1. Fit in the 12 claws.
2. With the screw, install the meter hood SUB-ASSY.

1. Engage the 4 clips and the claw and install the instrument panel side panel RH.

1. Fit in the 3 claws.
2. With the screw, install the instrument panel finish panel SUB-ASSY UPR.

1. Fit in the 6 tabs.
   CAUTION:

   If the claws are not correctly inserted, the claws may be damaged.

2. With the screw, install the instrument cluster finish panel garnish NO. 1.

1. Engage the 4 clips and 2 claws and install the instrument cluster finish panel SUB-ASSY CTR.

Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}