Roll Connector: Installation

Before attaching a new roll connector, apply a thin coat of grease contained in the connector onto the areas shown by the arrows.

Fig 1: Locating Grease Applying Areas On Roll Connector
Courtesy of SUBARU OF AMERICA, INC.
Install each part in the reverse order of removal.
Before installing steering wheel, be sure to adjust the direction of roll connector with steering. Refer to ADJUSTMENT .
Tightening torque:

Steering wheel: 39 N.m (3.98 kgf-m, 28.8 ft-lb)

Clearance:

Between column cover and steering wheel: 4 - 6 mm (0.16 - 0.24 in)